Air Parts Ejection System

The Blastmatic line offers an air ejection system for every application from the very basic to extremely sophisticated. All systems provide a powerful, precise, instant blast of air to safely eject a part from the die area. Eliminate unscientific trial and error cam adjustments by using an LSP control to simply add duration of the air blast.

The BlastMatic nozzle assemblies are designed with air stored 6 inches from the nozzle tip at the Univalve. When signaled by the press the Controller opens the Univalve allowing the air out the nozzle for the programmed time and duration to eject the stamped part. When the Controller turns off the UniValve goes into the rest mode.

BlastMatic
Air Parts Ejection
Catalog
Manual & Parts

More Efficient Parts Ejection Systems

BlastMatic
Area A: Air expended bringing the system up to force. The BlastMatic II shows a marked decrease in air use, because it is valved on/off at the unit. Area B: Air requird to do the job. This area represents the absolute smallest volume of area needed to eject the part. Area C: Air wasted due to inefficiencies. The BlastMatic II is shown to be more effective because of its focused air stream. Area D: Again, the BlastMatic II uses less air because there is no lengthy air line to be exhausted of unusable air.

BlastMatic

BlastMatic
By using the BlastMatic electronic controls, you can tab in the precise instant during the press syscle when you want a blast of air to start, as well as the length of time it stays on. This insures that the part is safely ejected from the die area.

Accessories

BlastMatic
Several accessories are available to help you fit Blastatic to your applications. See the brochure for complete details.

Have a Question?

Complete the form below.

Name(Required)
I am interested in (check all that apply)
This field is for validation purposes and should be left unchanged.